Installing Closet Bi Fold Doors Hardware

0

Bi fold doors hardware – Let’s starting with measure the width of the cabinet opening. If this opening is larger than 36 inches, you need two bifold doors. Pull 1/4 inch from the measurement and divide it by two, if you install two doors. Cut each track to this length with a hacksaw. Mark the center of the top of the cabinet with a pencil. Connect the two pieces of track together with the track connector plate. Attach these pieces to the cabinet header with screws.

Set turns into the holes on top of the top panels of the bifold doors. Gently tap them with a hammer. Set the guide comes in the holes on the indicative doors and arranges them in as well. Set the lower case in the holes on the bottom of bifold door guides and hammer them in. Set the frame bracket closet bi fold doors hardware on the floor directly. Before securing the jamb bracket with screws drill pilot holes in the doorjamb and the floor.

Push snugger guide into the center of the track. Measure up from the floor 36 inches. Make a mark at this level in the middle of the door. Drill a hole through the door. Put the back of the ripcord behind the door and twist the knob. Close doors and measure 12 inches from the floor. Make a mark at this height, at the inner edge of each door on the inside. Secure one door aligner on every door on this brand. And the closet bi fold doors hardware installation was finished.

These are reader choosen ideas bi fold doors, bi fold doors hardware, fold doors hardware

Share.

Comments are closed.